You can install a coat rack

By: Thomas Oak

Any person who can manage an electric drill, can install their own coat racks. It is quite effortless to find the required tools like an electric drill and a bubble level. The first thing one needs to make a decision where one has a requirement for a coat rack, frequently located by an exit door. As soon as the position is agreed on you will want to determined the elevation starting from the floor to set up your coat hooks. Typical mounting elevations are something like 40 inches for for little ones to use and roughly speaking 72 inches for adult use. The installed elevation is left to you depending on your wishes.

Locate the just about the center of the preferred position of your coat rack and measure from the flooring, if you are concerned about marking on the wall or are uncertain of the location place a bit of painters tape on the wall and mark on the painters tape. This prevents putting marks on the wall. Using a level, again you can use a bubble level place the level or laser on your mark and hold it level and mark the left and right ends of the position of the coat rack. If a bubble level or laser is not available you can take a piece of painters tape in the area the span of the coat rack and place it on the wall horizontally, stand back a short distance and carefully examine the painters tape does it look level? if not adjust until you have a nice level painters tape line.

After you have a good level painters tape line to guide you in the installing of a coat rack. You will need to fix the position the wall studs. The piece of painters tape that was put up prior is the perfect place to mark the center of each wall stud. A wall stud finder is the normal instrument used for locating the studs, a stud finder sells for in the area $10 to $15.00. Examine the wall over for a nail pop in the drywall or use a magnet to find a drywall nail. Wall studs are located every 16 inches on center.

Our goal is in site if your coat rack utilizes a through hole holding structure, locate your coat rack on the previously located level mark positioned on the painters tape. Take the installation screws place it in the installation hole and mark the wall, duplicate this for every installation hole. If your coat rack requires a key-hole installation method you will need to measure the distance relating to the key-holes and shift the dimensions to the painters tape. Once the key-holes are indicated you need to drill the screw key holes, confirm the screws and go for a twist drill bit slightly smaller than the screw and drill the holes. If you are mounting the coat rack with the trough hole installation procedure position the coat rack on the level line and drilled holes put in the installation screws and tighten evenly. If you are employing the key-hole installation procedure put in the screws run them in until the head of the screws extends out in the area 3/8 of an inch from the wall, put the coat rack over the screws and slide down. Youâ€™re new coat rack is now ready for coats.

Article Source: http://articleblender.com

About the Author: Thomas Oak he writes for www.pegandrail.com check out thier line of Maple wood coat racks or their complete line of hand crafted coat hooks for your home or office.

Please Rate this Article

Not yet Rated